Car Interior Removal Tool

• Enables easy removal of car panel upholstery.
• Removes panel clips without damaging surround areas.
• 235mm Door Upholstery Clip Remover 
• For quick release of door panels and upholstery clips. 
• Can be used for nearly all vehicles.

​Colour may vary. 

• Stainless steel Bottom eye x2
• Turnbuckles x2  H/D
• Stainless steel cables x2  
• Stainless steel Top eye X2
• Stainless steel Bottom eyes  x2 
• Plus heat shrink to make a neat job of your Bushcables.

Land Rover 200/300 Tdi Head Gasket Torque Angle Gauge

Used for precise torque adjustment on the head bolts of Land Rover engines when changing the head gasket. As outlined in the workshop manual.

For a 1/2" drive breaker bar.

Think security....

Complete number and letter stamping set. Useful for stamping your personal details onto vehicle parts or expensive tools, which may assist in the event of theft. 

Simply place the number or letter in the automatic punch and stamp where required. 

Punch Sizes 1/8"

All contained in a heavy duty plastic case. 

Includes:

26pc set of letters A-Z

9pc Set of number punches 0-8 (6 can be used as a 9)

1pc Decimal (.) punch

1pc Ampersand (&) punch

Battery Isolator Cut Off Terminal with Bridging Fuse Holder. 

ADD A SECURITY LAYER TO YOUR VEHICLE! 

Green tightening wheel for quick electrical disconnection.

Simply remove the negative lead from batery, bolt the switch to the negative battery post and reconnect the battery lead to the post on the end of the switch. 

Suitable for both diesel and petrol engines. 

Zinc copper plated, 86mm x 36mm

Colour of fuse holder may vary. 

• For press-fit vehicle joint components. Heavy duty, four function kit to service the removal/installation of ball joints, universal joints, truck brake anchor pins and 4WD ball joints. Both ball joint and 4WD ball joint service can be done without taking the control arm off. U-joint service can be performed on needle type U-joint bearings. Truck anchor pin service can be performed with pins up to 1-1/4" diameter.  Tool will even remove rusted and corroded parts. C-frame alone can be used to remove/replace universal joints. Comes in convenient blow mould storage case.
• Kit Includes:
  • Heavy Duty C-frame and forcing screw (1.106" x 7 threads per inch)
  • Installation and removal adaptors
  • Installation cup adaptor
  • Receiving and installation cups
  • 3 Receiver tubes: 2-3/4" x 2-1/4", 2-1/4" x 1-3/4", 1-3/4" x 1-3/4"

Adaptor Socker for Centre Diff Stake Nut

Ref: LRT-41-007 

Adaptor for centre differential stake nut to allow tightening by standard 1/2" drive socket tools.

When rebuilding a transfer box, this essential tool is for tigtening down the stake nut which retains the bearings.

Rebuilding a transfer box can be done with most common workshop tools, this socket is the only specialist tool not usually found in the workshop and is essential for tightening the stakenut to the correct torque value, during a transfer box rebuild operation, the stakenut is torqued and removed several times to check for correct tollerances, before the final torque and the stakenut set.

Application: LT230R and LT230T transfer gearboxes.

Manufactured from billet steel and electroplated for corrosion resistance to be a cost effective replica of the official LR tool number LRT-41-007 
Old tool number: 18G1423