Print

Fourby USB Clock Installation

Fourby USB Clock Installation

Fourby Multifunction clock installation:

Fourby_Clock_13 

These Instructions will show you how to replace your original Land Rover clock with the Fourby multifunction clock

Fourby_Clock

Use shims in these locations to push the retaining tabs up to assist the removal of the original clock, a feeler gauge makes a great set of shims.

Fourby_Clock_18

If you get the shims in the right spots you will be able to extract the clock. Feel around either side of the tab to locate it, then push the shims forwards from the front into center of the tabs to unlock. There are 4 Tabs

Fourby_Clock_20

The clock should just easily prise out of the surround

Fourby_Clock_21

use your thumb and forefinger to squeeze the connector to relase the hazzard light multiplug

Fourby_Clock_22

Fourby_Clock_23

Simply pull up on the smaller power connector multiplug and remove

Fourby_Clock_24

Fourby_Clock_25

Your Original clock should now be free from the dashboard

Fourby_Clock_26

Locate the tabs on either side of the Hazzard lights switch and squeeze them to release the switch from the original clock

Fourby_Clock_27

Fourby_Clock_28

Fourby_Clock_1

The switch will push out

Fourby_Clock_2

Insert this switch into your new Fourby multifuction clock

Fourby_Clock_3

Click the switch home into the new Fourby Multifunction Clock

Fourby_Clock_4

Insert the multiplug back into the hazzard light switch and route any thermal temp sensors.

Fourby_Clock_6

observe the following wires:

connect the BLACK wire from your new clock to the BLACK wire of the original wiring loom via the multiplug

Fourby_Clock_7

connect the red wire from your new clock to the GREEN wire of the original wiring loom via the multiplug

Fourby_Clock_8

Use tape to secure the wires.

Taping the connector might not be your idea of making a sound connection, we understand that. So use any method you wish to connect the wires, you could cut the cars loom and use crimp connectors or solder, or you could bring the original wiring loom connetors to the screw terminal block on the USB module. it's up to you....

Fourby_Clock_9

 

test the clock's connections by keying up the ignition, the clock should light up when your key is in and turned. Then offer the new clock up the dashboard,

 

Fourby_Clock_10

make sure there are no wires obstructiong the new clock from the back and push to click it into place in the dashboard

Fourby_Clock_11

your new Fourby Multifunction Clock is ready for Programming

Fourby_Clock_13

You will find a sticker in your parts box.

this is a QR link code to the programming instructions.

Add the sticker to your door jam, this will allow you to bring up the programming instructions on your phone at any time. you'll never be without the instructions in your Disco if you do this.

IMG_0625

IMG_0622

IMG_0623

or click the link below.

Fourby USB Clock Setup, Programming and Calibration instructions.